XFIRE AUDIO XFR2000.5 Owner's Manual

XFIRE AUDIO XFR2000.5 Owner's Manual

Xfr series mobile power amplifiers

Advertisement

AUDI O
XFR series multi channel
Mobile power amplifiers
Owners manual
xfireaudio.com

Advertisement

Table of Contents
loading

Summary of Contents for XFIRE AUDIO XFR2000.5

  • Page 1 AUDI O XFR series multi channel Mobile power amplifiers Owners manual xfireaudio.com...
  • Page 2 Life Amplified Introduction Welcome to XFIRE AUDIO ‘‘The New Breed Of Mobile Audio’’ . Congratulations on purchasing one of the finest autosound power amplifiers in existence. Born in The U.S.A from rigorous pursuits of exceptional sound, strength, performance, and style delivering kick ass mo- bile audio! Relentless pride and passion with 30 plus years of experience and excellence in the 12 volt industry.
  • Page 3: Specifications

    XFR series Life Amplified Specifications RMS power output (14.4V 0.15% THD): Model @ 2Ω @ 4Ω @ 4Ω Bridged 4x 150 W 4x 100 W 2x 300 W XFR2000.5 1x 400 W 1x 250 W 1x 400W XFR2000.4 4x 250 W 4x 150 W 2x 500 W XFR1800.2 2x 450 W 2x 300 W 1x 900 W XFR1200.4 4x 150 W...
  • Page 4: Installation

    XFR series Life Amplified Installation Actual installation of an XFR amplifier is not a difficult task. However, it takes a few tools, considerable care and precise attention to the instructions in this manual. If you doubt that you are up to the task, or your car proves to require special installation skills, we recommend having the work done by an authorized XFIRE AUDIO installation professional. Safety instructions • Always disconnect the negative (“-”) battery terminal before making any connections to the amplifier. • Fuse the positive (“+”) power lead, with the right value fuse within 30cm of the battery connection, the fuse rating for each XFR amplifier is given in the specifications. •...
  • Page 5 XFR series Life Amplified An XFR amplifier needs a few things to be happy in a car : Ventilation and a “ clean” source of power. VENTILATION Is important with any mobile amplifier. An amplifier can generate a considerable amount of heat when driven hard, and car interiors can get quite hot in the summer. Be careful when choosing a spot to mount the amplifier.
  • Page 6 XFR series Life Amplified Connections REM GND Remote turn on FUSE Use recommended BATTERY HEAD UNIT Ground fuse rating GROUND (-) Ground connection should be made to the vehicle’s chassis with a clean, bare metal, strong connec- tion keep the length of the ground wires as short as possible. Always use the same wire thickness as used for the positive 12V DC connection.
  • Page 7 4 - 8 Ohm Sub 2 - 8 Ohm Speaker BRIDGED MIN 4ohm BRIDGED MIN 4ohm 4 - 8 Ohm Sub 2 - 8 Ohm Speaker XFR2000.5 - Speakerwiring Stereo (Speakers) + Mono (Subwoofer) 2 - 8 Ohm Speaker 2ohm LEFT RIGHT...
  • Page 8 50Hz 5KHz 50Hz 5KHz 20Hz 5KHz FULL FULL GAIN GAIN BRIDGED MIN 4ohm (BPF) (BPF) INPUT INPUT CH2/R CH4/R XFR2000.5 CH1/2 BRIDGE +12V FUSE POWER FULL 50Hz 250Hz PROTECT POWER INPUT CH3/4 BRIDGE 50Hz 250Hz 18dB 40Hz 100Hz 50Hz 250Hz...
  • Page 9: Signal Input

    10 HIGH PASS FREQ. This control is used to set the High Pass filter frequency for the speaker outputs. 11 BASS BOOST This control is used to set a boost around a center frequency. (45Hz for XFR1200.4/1800.2) 12 BOOST FREQ. This control is used to set the center boost frequency of the bass boost (XFR2000.5 only). 13 PHASE This control is used to adjust the phase of the output signal. 14 LINE LEVEL OUTPUTS (RCA) These outputs can be used to route the input signal to a second amplifier.
  • Page 10: Setting The Controls

    Almost all problems can be eliminated by re-checking connections and settings in your system. Follow the steps below as a guide. If you cannot solve the problem, consult your XFIRE AUDIO installation professional. NO SOUND - POWER LED IS OFF Check the inline fuse(s) in the positive power cable, replace these if needed.
  • Page 11 XFR series Life Amplified POOR BASS RESPONSE Check if all speakers are connected with the right polarity, speakers connected out of phase will cancel each other resulting in a poor bass response. Check if the connected speakers/subwoofer(s) are OK, replace if needed. ENGINE NOISE Use only high quality shielded RCA cables. Ensure that all signal transfer wires (RCA, speaker cables etc.) are kept separately and away from power and ground wires.
  • Page 12 Some states do not allow limitations on the length of an implied warranty, thus limitations may not apply. No person shall assume for XFIRE AUDIO any other liability in connection with the sale of products.

This manual is also suitable for:

Xfr2000.4Xfr1800.2Xfr1200.4

Table of Contents